BSS AR133 Di box

Aprašymas

The Active Direct Inject box shall provide a transformer balanced and isolated feed from a source input via a 1/4" TRS jack or 3-pin XLR-type connector. The output of the DI box shall be via an XLR connector. The unit shall also provide a 1/4" TRS jack in parallel with the input to act as a link for line bridging. The link shall be a direct feed from the input, or shall optionally be fed from an actively buffered input signal.

The unit shall be powered either via a phantom power source, or via a standard PP3 type 9 volt battery. An led shall illuminate continuously to show power is provided by a phantom source, or flash approximately every 2 seconds if powered by the battery.

Switches shall be provided for: EARTH LIFT (output pin 1 disconnected from unit ground), INPUT ATTENUATION (of 0, 20 or 40dB), and Power On/Off.

The unit shall be housed in an aluminium extrusion fitted with isolating side-cheeks. The unit shall be sufficiently screened so it is not susceptible to external magnetic fields.

Specifications:

• Input Impedance:  1 mOhm (pad at 0dB), 47 kOhm (pad at -20dB or -40dB)
• Max Input:  +9dBu (pad at 0dB), +29dBu (pad at -20dB), +49dBu (pad at -40dB)
• Input Connectors:  Two Parallel 1/4" jack connectors (Tip Hot +ve, Sleeve ground), and a parallel XLR connector (unbalanced) (Pin 2 Hot +ve, Pin 1 & 3 ground)
• Output:  Transformer Balanced
• Max Output:  +8dBu into 600 Ohms or greater
• Output Connectors:  XLR3-32 or equivalent
• THD:  < 0.005% at 1khz, 0dbu output
• Noise:  < -105db unweighted, 22hz-22khz, rms*
• Frequency Response:  30Hz to 20kHz, +0dB/-1dB
• Main/Standby battery:  9 volt PP3 type, preferably alkaline
• Power Consumption:  on phantom: less than 7.5mA, on battery: less than 2mA.
• Phantom Power:  +20 volts DC to +48 volts DC
• Unit Weight:  650 g, excluding batteries
• Dimensions:  59 mm x 124 mm x 143 mm (2.3" x 4.9" x 5.6")